Current position > News detail
『ABB flowmeter』Related information(clamp on meter|electromagnetic meter|venturi meterrotameter|orifice meter|ultrasonic flow meter|mass flow meter|coriolis mass flow meter|coriolis flow meter|magnetic flow meter|magmeter flow meter|magflow flow meter|mag meter flow meter|electromagnetic flow meter|vortex flow meter|turbine flow meter|thermal mass flow meter|thermal flow meter|rotameter flow meter)
1. How to eliminate ABB electromagnetic flowmeter alarm?
The elimination of ABB electromagnetic flowmeter alarm needs to be handled according to the specific alarm type. Common types include air traffic alarm (such as E01) and system failure (SYS). The following are targeted solutions:
1. Steps for eliminating air traffic alarm (E01): Check the pipeline status to confirm that the pipeline is completely filled with liquid, avoiding bubbles or air traffic phenomena.
. Check whether the upstream valve is fully open and whether the pump is running normally, and eliminate false alarms caused by insufficient flow in the air pipe. If there are high points or areas prone to gas accumulation in the pipeline, it is recommended to adjust the installation angle or install an exhaust valve. Check the electrode status and clean the dirt on the electrode surface (such as oil film, scale, biofilm). Use a multimeter to measure the resistance between the electrodes, and the normal value should be less than 50k Ω. If the electrode is covered or corroded, it needs to be cleaned with 5% dilute hydrochloric acid (strong corrosive media require shutdown operation). After cleaning, rinse with clean water and dry. Check the signal line and grounding to ensure that the signal line is connected correctly, without looseness or damage; Plastic pipes require additional grounding, and the grounding resistance should be less than 100 Ω. Check if the grounding wire is reliably connected to the ground to avoid signal interference caused by poor grounding. Adjust the alarm threshold and enter the settings menu. Based on the conductivity of the medium and the resistance rate in the full tube state, set the air tube alarm threshold reaso_600x400.jpg)
1, SIG2, and SIGGND. If the "empty tube" prompt is cancelled, the converter is normal; Otherwise, the sensor coil or converter hardware needs to be returned to the factory for testing. Optimize installation location to avoid installation at high points in pipelines. It is recommended to install vertically upwards (with fluid flowing from bottom to top); If the position cannot be changed, a back pressure valve or buffer tank can be installed to maintain the full pipe state.
2. Elimination steps for system failure (SYS): Power off, restart, turn off the power, wait for 30 seconds before restarting, and observe whether it is reset (about 60% of temporary interference can be eliminated by restarting).
. Check the power supply voltage to confirm that it is stable within the range of 220V ± 10%. If the voltage fluctuates greatly, it is recommended to install UPS (uninterruptible power supply). View historical alarm codes and enter the menu to view historical alarm records (for example, for ABB models, press and hold the OK button for 5 seconds), and locate the specific fault point based on the code. If the alarm persists and cannot be resolved by restarting during factory inspection or hardware replacement, the PCB board needs to be inspected or the signal converter needs to be replaced (non professionals are prohibited from disassembling to avoid damaging the equipment).III. Preventive Maintenance Recommendation Regu